7G-DCT Problem Kisspoint

[andresz28]

I have a problem with my CLA250 2018 transmission.
It has code 287C00 and cannot perform any retraining procedures. Can shift from park to neutral, but nothing more. When I try to do a full basic adaptation it stops after a couple of minutes and the result is "Grudeinmessung Kisspoint: Übrige Vorbedingung verletzt".
The TCM was updated and SCN performed online, the transmission valve body, TCM and transmission fluid were replaced.
What else do you suggest me to do?

 

[lashe]

1. Is there enough oil?
2. When adaptation is about to start, check if the temp rate is accepted, and not before it reaches the second stage.
3. Resolve this speed sensor error before adapting.

 

[aba63]

This DTC refers to a mechanical problem in the gearbox. You can bypass this DTC and make it working again by flashing the TCM with a virgin file.
After this, adaptation cannot be carried out under any circumstances unless you repair your gearbox.

 

[andresz28]

1. Is there enough oil?
2. When adaptation is about to start, check if the temp rate is accepted, and not before it reaches the second stage.
3. Resolve this speed sensor error before adapting.

Yes, oil is in 4 and measured at 40°C and 75°.
I'm waiting for the customer to bring me an ABS sensor.

 

[andresz28]

This DTC refers to a mechanical problem in the gearbox. You can bypass this DTC and make it working again by flashing the TCM with a virgin file.
After this, adaptation cannot be carried out under any circumstances unless you repair your gearbox.

The TCM is brand new and was SCN coded because before replacing the TCU did not have drive authorization.
Will it work if I clear the DTC?

 

[andresz28]

Is there a way to copy adaptive settings from a working transmission EEPROM to another?

 

[andresz28]

SOLVED! ABS sensor was causing me problems.