Openport 2.0 CLIP Registry Entry and Roll Back

  •  Extras Download 
  • Thread starterninjahwdp
  • Start date
N
ninjahwdp
New member
Joined
02.01.2024
Messages
12
Solutions
1
Reaction score
23
I found an easy way to use Openport 2.0 with CLIP.
Just use it. Two REG files: "Open Port for CLIP.reg" for use with CLIP and "OpenPort ORG.reg" for use as before with other software.
 
Download attachments
  • open.7z
    External link · Views: 14
  • Like [+1]
Reactions:lenvm, nemiro, bogdandpr and 7 others
Has it been tested by anyone?
 
I have tested this several times and it works fine with cars with full CAN system (2006 and newer).
 
I tried to use "Open Port for CLIP.reg" with CLIP v237, but unfortunately without success. CLIP reports that the device is not found.
What versions of CLIP has this registry entry been tested with? And do I need to do anything else to use the J2534 Passthru device with CLIP?
 
I was able to resolve the issue where Openport 2.0 was not detected by CLIP by following these steps.
I set "Vendor"="79B" and "Name"="1B" in the Tactrix device's Passthru registry settings.
The registry entry is located in "HKEY_LOCAL_MACHINE\SOFTWARE\PassThruSupport.04.04\<VCI>".
 

Similar threads

ker0de
  • ker0de
  • Diagnostic and engineering software
Replies
0
Views
1K
ker0de
ker0de
crypt0ninja
  • crypt0ninja
  • Diagnostic and engineering software
Replies
6
Views
2K
lenvm
L
R00TR0w
  • Sticky
  • R00TR0w
  • Diagnostic and engineering software
2
Replies
13
Views
7K
carman777
C
Back
Top Bottom