Retrain Coding

[ahhl]

I am new to coding and know a few tricks to relearn my car.
I did online coding with J2534 interface (turn on auto park side, turn on Distronic Pro) but the coder is on the other side of the world from me and I can only arrange a coding session at night (midnight my time). So it is inconvenient. So my problem is that when Mercedes-Benz workshop replaces module or wire that should retrain module, they are locked. Can't do it. So I have to arrange a session with the coder to retrain module and midnight is always a problem.

So I managed to get Xentry 6/23.
I don't know where to start. Sorry, I might even be using the wrong term.

 

[Fotom]

It looks like you need a little practice coding your car in general. Xentry offers very little in the way of coding, at least when you are offline and don't have a Mercedes account.

For coding, use Vediamo or DTS Monaco (depending on your car and what might be easier for you). The codings you've done so far indicate that you have at least a newer car (W205 or W213), so I'd go with DTS Monaco.

Once you have your DTS Monaco system set up and the coding you want, make a backup. Next time it will be almost a one-button solution to change the coding back.

 

[mic4130]

To code these functions you will need Vediamo or DTS Monaco, and software that requires some special files to read the data from the car. In any case, you will find everything you need on this forum, just dig around.

 

[ahhl]

Do I even need DTS Monaco to retrain the sensor?

 

[mic4130]

Specific sensor? Xentry will allow you to see the workflow of each sensor.

 

[Fotom]

Oh, I get it, you want to reset the adaptation or something like that. Then that's right, you don't need any other program, Xentry will "retrain" or reset the adaptive values.