Problem with the Mercedes MFK SMPC213 Camera

[BMGarage]

I need help installing an MFK camera - I am using a used unit with the same part number (both the software and hardware versions match).
I installed this device - XENTRY detects it, but it throws errors.
It appears that these errors are preventing calibration.
I copied the variant coding from the original module to the new one. I performed the necessary procedures (EVC) and a Hard Reset, but it did not help.
Can anyone help with this (suggest techniques or a sequence of steps in DTS)?

 

[BMGarage]

Active errors:

B228600 - The calibration of the control unit has been lost or not carried out.
B229B56 - The multifunction camera has a malfunction an incorrect or in compatible was detected.

 

[Nacka]

Could you check which hardware and software versions were installed on the old SMPC, and which are on the new one?
You can initiate the calibration process using XENTRY and drive around the premises. Alternatively, you will need a printed A4-sized document positioned at the correct height and distance - though XENTRY does provide the necessary calibration information.