W203 retrofit LED error message eliminate using Vediamo

[zebra]

Just wonder if it's possible. Changed Auxito LED for both high low headlights which claimed ertor message free LED, but apparently not. Now wonder if I can use Vediamo 4.02.02 + Tactrix openport 2.0 to change code for current threshhold to avoid triggering error message. I saw someone posted in othet place suggested it. Like this:
Go to the variant coding of the Front SAM in DTS

Monaco or Vediamo. There will be a low-beam hardware setting section. Reduce both values for the Current Limit and Overload Limit.

For example, for the low beam, SC Schwelle_Abblendlicht _links and _rechts will be 17810, then you can change it to 4000 (for example). OL_Schwelle_Abblendlicht_links and * _rechts also needs to be changed from 256 to 20 (for example). You can do these for the high beam and also turn signal if you are going to change it to LED.

Any one has any idea of the value change here for 2003 w203?

 

[Pesek]

Have you solved it? I installed LEDs in the fog lights and there were errors, so I installed resistors there. But it will be better with a software update.

 

[EduardNN]

As far as I know, on cars produced in 2000...2008, the coding of the output current of the channel for incandescent lamps is not provided. Only the halogen or xenon options for headlights or halogen\LED for rear lights are coded (for example, x\w164).