U
I tried to do something to my car using the Autel Ultra and of course, unfortunately, I managed to mess everything up.
I completed the EZS control unit adaptation process using Autel, and immediately after completing the process, I received the error mentioned in the title. Then my Lane Assist camera started displaying an incomplete configuration message, and my SAM showed an error related to an incorrect signal on the driver's door sensor.
After this, I performed an SCN restore from the Autel cloud (after making a backup), but EZS still shows an incomplete configuration. The restore was successful, and I didn't change anything in the camera or SAM module, as I know they should disappear after fixing EZS.
So, my problem now is how to complete the EZS setup. My car runs fine, but the Lane Assist system isn't working, and the SAM reports a driver's door contact error, even though the dashboard displays it correctly when the door is opened.
I have a code post-processing routine I could run on it, but frankly, I'm afraid right now.
I know everyone will ask why I used Autel, but I'm currently in the process of acquiring a DOIP interface and the corresponding software.
In the meantime, any information or tips would be very helpful, although I know most of you use XENTRY. But perhaps your feedback will help me figure out what I need to do next. I could also sync the Mercedes SCN server with EZS, but since restoring from my backup didn't work, I'm not sure what will happen with this one.
I completed the EZS control unit adaptation process using Autel, and immediately after completing the process, I received the error mentioned in the title. Then my Lane Assist camera started displaying an incomplete configuration message, and my SAM showed an error related to an incorrect signal on the driver's door sensor.
After this, I performed an SCN restore from the Autel cloud (after making a backup), but EZS still shows an incomplete configuration. The restore was successful, and I didn't change anything in the camera or SAM module, as I know they should disappear after fixing EZS.
So, my problem now is how to complete the EZS setup. My car runs fine, but the Lane Assist system isn't working, and the SAM reports a driver's door contact error, even though the dashboard displays it correctly when the door is opened.
I have a code post-processing routine I could run on it, but frankly, I'm afraid right now.
I know everyone will ask why I used Autel, but I'm currently in the process of acquiring a DOIP interface and the corresponding software.
In the meantime, any information or tips would be very helpful, although I know most of you use XENTRY. But perhaps your feedback will help me figure out what I need to do next. I could also sync the Mercedes SCN server with EZS, but since restoring from my backup didn't work, I'm not sure what will happen with this one.
