Mercedes-Benz WIS ASRA Standalone v07.2021

[R00TR0w]

The software was recompiled to support XTP (XENTRY Pass Thru).

Don't forget about the second file if you use the key for XENTRY from a FREE generator. Otherwise, WIS will not start from DAS.
This file is not needed if you are using my commercial activation.

Link updated 24.10.2023

 

[emems]

I have a problem with WIS, after searching for some documents it gives me a drawing error and I can’t view anything. When I restart the application I get an error and can no longer run it until I restart my computer.

 

[R00TR0w]

I can't simulate a problem like this.

 

[Diagnos11]

I need help.
After installing and activating I get the following error:


Help please, how to fix it?

 

[R00TR0w]

It does not require any activation or modification and has been installed on several hundred computers without problems.
If you do not use this version, there is no point in writing here.

 

[o_Rage_o]

Hi R00TR0w - thanks for compiling all of this. Very smooth installation.

Symptom:

When I enter the VIN into WIS, the message "Vehicle Identification Number Not Found" or "Data Card Cannot be Displayed" appears. The car is up to 2018.

Checked:

- EWA is running on port 5191
- EPC can accept a VIN without issue
- WIS can accept model without issue 207367 for instance
- WIS_CFG.XML

<PARAMETER name="datacardUrl" >hxxp://localhost:5191/EPC-net/datacardapi</PARAMETER>
<!- URL of datacard service for Snap On's datacard view: ->
<PARAMETER name="datacard_V2_Url" >hxxp://localhost:5191/EPC-net/dcapi</PARAMETER>

The EPC installation was done manually via ISOs and then using your EPC Activation, during installation I chose the second option (will install WIS Standalone later).

Any thoughts on what I can check next?
Was going to install the EPC again using all your files, not just the activation part, in case that might be the problem.

 

[R00TR0w]

Standalone = Standalone.
WIS Standalone by its nature cannot use the EWA net database, like EPC database for "data card" from EWA net.
The "data card" has been disabled there since the first version because of this.

 

[o_Rage_o]

Standalone = Standalone.
WIS Standalone by its nature cannot use the EWA net database, like EPC database for "data card" from EWA net.
The "data card" has been disabled there since the first version because of this.

Thanks so much for the kind explanation! Now I understand the connection architecture better.

 

[R00TR0w]

The software was recompiled to support XDOS and XPT v12.2023 and above.

Link updated 25.11.2023

 

[c250]

I just want to know if the mentioned version is valid for 2023 W206 models.